Operation Manual

41 DVB-S Receiver
GB
6.4.1 USB-STB UPGRADE
This option allows updating the software of
the receiver with the received data from a
USB memory device. To do it, connect a USB
memory device to the receiver and accede to
this menu option.
The last software version to be loaded must
be placed at the root path of your USB device.
1. Upgrade Mode: the mode of the upgrade
to be choosed, Press [Vol◄/►] to select
Software, Whole, User Interface, Default
DB, CAS and Ch.List & Setting.
2. In the “Software” item press [Vol◄/►] to select the file which you want to scan or press
[OK] to open the “USB list” to select directly with [CH▲/▼], and press [OK] to finish
the selection.
3. Start: Press [OK] to start upgrade.
4. Once the file has been loaded, it requires the conformity to end the upgrading proc-
ess, writing into the receiver “Are you sure to burn flash ?”. Press [OK] to upgrade
the receiver. In case during the reading of the file, it is corrupted or it would be a not
appropriated for this model of receiver, an alert message would appear “Error reading
the USB disk”.
5. After pressing [OK] the receiver will write into the Flash memory, and it will reboot to
end the upgrading process.
NOTE: The upgrade file is the binary file, *.bin. Only the files, which extend name is bin,
would be displayed. User need put the upgrade file under root of USB card.
6.4.2 BACKUP TO USB
This function allows you Dump Software and
Ch.List & Setting fo the receiver to external
hard drives.
1. press [Vol◄/►] to change the backup
mode. backup mode include: Dump Soft-
ware and Ch.List & Setting.
2. Mark “Start” on the master reeciver and
press [OK] to start Backup.
3. Press [MENU/EXIT] to save the setting
without Backup.
6. TOLLS