Installation Instructions

41 DVB-S Receiver

5.6 Power setting

• Here you can set the power output to

the LNB. If your receiver is connected

to the LNB directly then you need to set

the LNB

Power to “On”. If your receiver is

connected

to a multi switch (SMATV signal

distribution system) then it may be that

you don’t need to provide the power to the

LNB. But since this is depending on the

kind of installed distribution system we

recommend you to contact your installer or to refer to the user manual of this system

to get the correct information.

• You also just can change this setting and check if you still can receive the channels.

If the LNB Power is off and you still can see all channels then we recommend this

setting in order to save energy.

5.7 RCU Position Switch

When many receivers are working at the

same time, In order to prevent the other

receivers to be disturbed when operating

the current receiver, here you can switch

RCU position, it has three items: Position 1,

Position 2 and Position 3, default position is

Position 1.

5. SYSTEM SETUP

BDA Imperial DB 2_basic_GB_MK.in41 41BDA Imperial DB 2_basic_GB_MK.in41 41 07.11.2008 13:29:55 Uhr07.11.2008 13:29:55 Uhr