Installation Instructions

9 DVB-S Receiver

2.1 Switch on STB

Switch the [Device’s Main Power] switch on.

When the STB is ﬁ rst used it will display “Quick Setup” window. you will set Language,

First Audio, Second Audio, LNB Power, Antenna Setup and Multi Search.

? Frequently Asked Question

Q: The power of my STB is on and it is running in TV mode but the TV screen shows

nothing:

A: Make sure the TV set has been set to the correct video input (not the TV channels).

For example, if you have connected the unit to the video1 input of the TV set then you

need to select the corresponding input of the TV. Mostly it is done with the AV button

of the TVs remote control unit.

Q: My STB is running in TV mode but the TV screen shows nothing except one ball

and “No Signal”.

A: That means the channel you selected has no signal. This can be caused by several

reasons:

1. The channel you selected is not from the satellite to which your dish is pointing.

Select another channel.

2. The signal of current TV channel is too weak. You can try to change to other

channels with a stronger signal. If the problems still exist, please consult your local

dealer or installer for technical service.

3. You selected the wrong LNB type in the installation menu or your DiSEqC switch

conﬁ guration is not correct.

2.2 Standby Mode

1. Press [Power] button to switch from TV/radio mode to standby mode

2. In standby mode press [Power] button again to switch back to TV/radio mode. The

last active channel will be showed.

3. To switch off the STB complete press the main power button.

2. BASIC OPERATIONS

BDA Imperial DB 2_basic_GB_MK.in9 9BDA Imperial DB 2_basic_GB_MK.in9 9 07.11.2008 13:30:24 Uhr07.11.2008 13:30:24 Uhr