Installation Instructions

30Installation Guide

• LNB Type: Press [Vol ] to switch

among “Standard”, “User” and “Univer-

sal” mode.

For Example: If you use a Dual LNB,

then you should select “User” option

in “LNB Type” and set the correct fre-

quency in LNB type.

• 22K: Use [Vol

] to switch “ON” and

“Off”. The 22KHz signal is used in KU

universal LNBs to change between low band and high band.

! Notice:

After choosing LNB type “Universal” you cannot modify 22K.

• DiSEqC1.0: Use [Vol ] to switch the options or press [OK] to open the DiS-

EqC1.0 option list to select directly with [CH ], press [OK] to conﬁ rm it.

• DiSEqC1.1: Use [Vol ] to switch DiSEqC1.1 option or press [OK] to enter

DiSEqC1.1 option to select directly with [CH ], press [OK] to conﬁ rm it. The op-

tions of this item are: Disable/CCard1 M1 Port1/CCard1 M1 Port2/

CCard1 M1 Port3/CCard1 M1 Port4/CCard1 M2 Port1/CCard1 M2 Port2/

CCard1 M2 Port3/CCard1 M2 Port4/CCard1 M3 Port1/CCard1 M3 Port2/

CCard1 M3 Port3/CCard1 M3 Port4/CCard2 Port1/CCard2 Port2/

CCard2 Port3/CCard2 Port4/CCard2 Port5/CCard2 Port6/CCard2 Port7/

CCard2 Port8/CCard2 Port9/CCard2 Port10/CCard2 Port11/

CCard2 Port12/CCard2 Port13/CCard2 Port14/CCard2 Port15/

CCard2 Port16.

• Positioner: Press [Vol ] to select between “Off/DiSEqC1.2/USALS”.

! Notice:

When you select “DiSEqC1.2 or USALS”, “DiSEqC1.0” and “DiSEqC1.1” items will be

disabled.

• Polarity: Press [Vol ] to switch between “Auto/H/V ”.

• Toneburst: Press [Vol ] to switch this function “On” or “Off”.

5. After you completed your modiﬁ cation, on the “TP Scan” item, press [OK] twice to

start scanning.

4. INSTALLATION

BDA Imperial DB 2_basic_GB_MK.in30 30BDA Imperial DB 2_basic_GB_MK.in30 30 07.11.2008 13:30:05 Uhr07.11.2008 13:30:05 Uhr