Installation Instructions

24Installation Guide
TROUBLE SHOOTING
Note:
If you have tried all of the actions suggested above, without solving the problem,
please contact your dealer or a technical hotline.
Problem
The display on the front
panel does not light up.
No sound or picture,
but the front panel
shows red light.
No sound or picture.
Bad picture/
blocking error
The RCU is not working.
What to do
Check that the main cable
is plugged into the power socket.
Press the standby button.
Check the cable connections,
antenna and other equipment
connected between the antenna
and the receiver.
Connect a signal attenuator to
the antenna input.
Change to an antenna with lower
noise factor.
Change the antenna.
Change the batteries.
Aim RCU at the receiver or check
that nothing blocks the front
panel.
Possible causes
Main cable is
not connected.
The receiver is in
standby mode.
No signal or weak signal.
Signal is too strong.
Antenna noise factor
too high.
The antenna is faulty.
Battery exhausted.
RCU is incorrectly aimed.
BDA digibox Basic-T_GB.indd 24BDA digibox Basic-T_GB.indd 24 22.02.2008 16:21:41 Uhr22.02.2008 16:21:41 Uhr