Installation guide

Installing a DECarray Cabinet

4.3 Installing the DECarray Cabinet in a Single-System Conﬁguration

4.3.4 Powering Up the DECarray Cabinet

Once the DECarray cabinet has been installed and labeled, you are ready to

apply power. Follow the steps in order.

CAUTION

Make sure that the ac power switch on each storage enclosure and

magazine tape ISE installed is in the off position.

1. At the rear of the DECarray cabinet, turn the power controller on

(Figure 4–8). Make sure that the BUS/OFF/ON switch is in the down

position.

Figure 4–8 Power Controller Circuit Breaker

J10

J11

J12

J13

FUSE

LABEL

CIRCUIT

BREAKER

POWER CORD

STRAIN RELIEF

GROMMETED

CORD

OPENING

POWER CONTROL

BUS CONNECTORS

POWER

CORD

FUSE

BUS/OFF/ON SWITCH

(SYMBOLS CLOCKWISE FROM TOP)

UNDELAYED

DELAYED

(0.5 SEC)

SERIAL/LOGO

LABEL

881

SHR-X0107-90

Installing a DECarray Cabinet 4–25