Installation guide

Installing a DECarray Cabinet

4.2 Inspecting the DECarray Cabinet

Figure 4–3 Power Controller

J10

J11

J12

J13

FUSE

LABEL

CIRCUIT

BREAKER

POWER CORD

STRAIN RELIEF

GROMMETED

CORD

OPENING

POWER CONTROL

BUS CONNECTORS

POWER

CORD

FUSE

BUS/OFF/ON SWITCH

(SYMBOLS CLOCKWISE FROM TOP)

UNDELAYED

DELAYED

(0.5 SEC)

SERIAL/LOGO

LABEL

881

SHR-X0107-90

5. For each storage enclosure and magazine tape ISE installed, check that the

ac power cord is correctly seated.

6. Make sure that each storage enclosure and magazine tape ISE has the

correct voltage selected for the power supplied to the power controller.

Note that each has a voltage label for its factory setting.

7. Make sure that the voltage selection switches for each storage enclosure

and magazine tape ISE are in the correct position for the power supplied

on the power controller.

8. Make sure that the shipping screw on all magazine tape ISEs has been

loosened. This screw is in the rear upper right corner of the magazine tape

ISE. Loosen the screw; do not remove it.

9. Make sure that all DSSI connectors on the DECarray I/O panel are ﬁrmly

seated.

Installing a DECarray Cabinet 4–15