Installation guide

Installing a DECarray Cabinet

4.2 Inspecting the DECarray Cabinet

Before beginning the conﬁguration, inspect the DECarray cabinet from the

front, then from the rear.

1. Open the front and rear cabinet doors.

a. Turn the two 3/16-inch hex-Allen fasteners at the right edge of the door

counterclockwise to unlock them.

b. For each door, grasp the door by its edges, and pull toward you.

2. Check the settings on the OCP of each storage enclosure, located at the

front of the DECarray cabinet (Figures 4–1 and 4–2).

For SF3x Enclosures:

a. Make sure the Ready and Write Protect switches are in the out

position.

b. Make sure the MSCP/Fault LED is unlit.

c. Make sure the dc power switch for each ISE in the enclosure is off.

Figure 4–1 SF3x Operator Control Panel

ABCDEF

Front

ABCDEF

Rear

Ready

Write

Protect

Fault

MA-0433-92.DG

Installing a DECarray Cabinet 4–11