Installation guide

Unpacking the DECarray

3.5 Inspecting the DECarray Cabinet

Figure 3–8 Power Controller

J10

J11

J12

J13

FUSE

LABEL

CIRCUIT

BREAKER

POWER CORD

STRAIN RELIEF

GROMMETED

CORD

OPENING

POWER CONTROL

BUS CONNECTORS

POWER

CORD

FUSE

BUS/OFF/ON SWITCH

(SYMBOLS CLOCKWISE FROM TOP)

UNDELAYED

DELAYED

(0.5 SEC)

SERIAL/LOGO

LABEL

881

SHR-X0107-90

7. Check the ac power cords for each storage enclosure and magazine tape

installed. Make sure that each is correctly seated.

8. Make sure that the voltage selection switches for each storage enclosure

and magazine tape are in the correct position for the power supplied by the

installation site (Figures 3–9, 3–10, and 3–11).

9. Loosen the shipping screw on all magazine tapes in the storage array. This

screw is in the right rear upper corner.

10. Make sure that all DSSI cables internal to the storage array are ﬁrmly

seated.

11. Close the cabinet doors; turn the hex-Allen fasteners one quarter turn

clockwise to lock them.

3–12 Unpacking the DECarray