Installation guide

Converting a Single-System Conﬁguration to a DSSI VAXcluster Conﬁguration

C.2 Conversion Procedure

C.2.6 Final Veriﬁcation

Once the DECarray conversion, cabling and labeling, and the powering up

steps are complete, you are ready to conﬁgure the DSSI subsystem and verify

the correct operation of each ISE in the array with the host system.

Refer to the KFMSA Module Installation and User Manual, Magazine Tape

ISE Service Manual, and the Integrated Storage Element User Guide for

detailed information on the correct operation of each ISE. These manuals

contain procedures for establishing the communications between the ISEs, the

adapter module, and the system. They also contain step-by-step procedures for

reconﬁguring the system with its newly installed DSSI devices.

Refer to the manuals for the disk ISE and tape ISE for detailed information on

the local programs in the ISEs.

Converting a Single-System Conﬁguration to a DSSI VAXcluster Conﬁguration C–21