Installation guide

Converting a Single-System Conﬁguration to a DSSI VAXcluster Conﬁguration

C.2 Conversion Procedure

C.2.3.3 Placing the Labels

Once the labels have been ﬁlled out, place them on the DSSI cables and the

SF7x OCP doors. Also place a label on the front of the magazine tape ISE.

Place cable labels four inches behind the DSSI connector on both ends of the

DSSI cable (Figure C–7).

Figure C–7 Placing a Label on a DSSI Cable

LABEL

SHR-X0108-90

C–16 Converting a Single-System Conﬁguration to a DSSI VAXcluster Conﬁguration