Installation guide

Converting a Single-System Conﬁguration to a DSSI VAXcluster Conﬁguration

C.2 Conversion Procedure

C.2.3.2 Filling Out the Labels

The labels are available in two sizes; the larger one for the DSSI cables, and

the smaller one for the inside of the SF7x OCP door, the front panel of a

magazine tape ISE, and the host system I/O panel.

Refer to the inside cover of the SF Family Label Booklet for instructions on

ﬁlling out these labels.

For the DSSI VAXcluster conﬁguration, use the following colored labels on the

SF7x OCP doors, the front panels of the magazine tape ISEs, and all DSSI

cables.

Label Color DECarray Port/DECarray Position

Blue Port 1, position 5 and/or 1, port 9

Red Port 2, position 6 and/or 2, port 10

Yellow Port 3, position 3, port 11

Green Port 4, position 4, port 12

Blue with white stripe Port 5, position 7, port 13

Red with white stripe Port 6, position 8, port 14

Converting a Single-System Conﬁguration to a DSSI VAXcluster Conﬁguration C–15