Installation guide

Converting a Single-System Configuration to a DSSI VAXcluster Configuration
CAUTION
The following procedure assumes that the DECarray, and the SF7x
storage enclosures and magazine tape ISEs in the DECarray, have
been correctly installed and configured according to the standard bus
and configuration guidelines in this installation guide.
Locate the system configuration sheet (an example can be found in
Figure C–1) and ensure that it is filled out. If the system configuration
sheet does not exist, fill one out immediately.
WARNING
Only one SF7x storage enclosure inner assembly should be extended on
the slide mount at a time.
Take all possible ESD precautions when performing this procedure.
Wear a correctly grounded ESD strap.
Perform each step in the order presented.
C–2 Converting a Single-System Configuration to a DSSI VAXcluster Configuration