Installation guide

Installing an SF3x-HK and SF7x-UK Upgrade Kit

B.4 Powering Up the ISEs

Once all of the previous steps have been performed, use the following steps to

power up the ISEs:

1. At the rear of the DECarray cabinet, turn the power controller circuit

breaker on.

2. For all SF7x storage enclosures and magazine tape ISEs, turn the ac power

switches at the rear of each to their 1 or on position.

3. For all SF7x storage enclosures, press all drive dc power switches to their

in position.

4. Place each disk ISE installed in the DECarray on-line by pressing all OCP

Ready buttons to their in position.

B.5 Bringing the Disk ISEs On-Line

Refer to your system or DSSI adapter documentation for instructions on

conﬁguring a single-system and DSSI VAXcluster conﬁguration.

B–12 Installing an SF3x-HK and SF7x-UK Upgrade Kit