Installation guide

Installing an SF3x-HK and SF7x-UK Upgrade Kit
B.3 Installing an RF7x ISE into an SF7x-HK Storage Enclosure
c. Make sure that the disk ISE is locked into place and tighten the wedges.
d. Connect the cables (Figure B–4) in the following order: 6-pin power cable,
10-pin OCP cable, and 50-pin DSSI cable. The connectors are keyed so that
the cables cannot be installed incorrectly.
Figure B–4 Cabling the RF7x Disk ISE
NOTE TO
ILLUSTRATOR:
front panel for this
hardware is SHR_X1127_89
ISOL and reduced
17/64 (.265625)
Write
Protect
Fault
DSSI
ID
Write
Protect
Ready
Fault
DSSI
ID
d
i
g
i
t
a
l
Ready
SHR-X0135A-90
10-PIN
OCP CABLE
6-PIN DRIVE
POWER CABLE
DSSI CABLE
B–10 Installing an SF3x-HK and SF7x-UK Upgrade Kit