Installation guide

Installation Troubleshooting
9.3 Removing an RF Disk ISE from an SF7x Storage Enclosure
5. Position the RF disk ISE as shown in Figure 9–5 and install the disk ISE
in the enclosure. Slide the disk ISE gently into place, while holding all
cables out of the way. Do not force the disk ISE.
6. Make sure that the disk ISE is locked into place and tighten the wedges.
7. Connect all cables as shown in Figure 9–7. Connectors are keyed so that
the cables cannot be installed incorrectly.
Figure 9–7 Cabling the RF Disk ISE
NOTE TO
ILLUSTRATOR:
front panel for this
hardware is SHR_X1127_89
ISOL and reduced
17/64 (.265625)
Write
Protect
Fault
DSSI
ID
Write
Protect
Ready
Fault
DSSI
ID
d
i
g
i
t
a
l
Ready
SHR-X0135A-90
10-PIN
OCP CABLE
6-PIN DRIVE
POWER CABLE
DSSI CABLE
9–16 Installation Troubleshooting