Installation guide

Installing the Magazine Tape ISE in a DECarray Cabinet
8.3 Powering Up the Magazine Tape ISE
8.3 Powering Up the Magazine Tape ISE
Follow these steps to apply power to a newly installed magazine tape ISE.
1. Turn the ac power switch on the rear of the magazine tape ISE to the on
position.
a. All its OCP indicators turn on (generally within 15 seconds).
b. While the elevator scans the magazine, all OCP indicators, except for
Power On, turn off.
c. Assuming the ISE has a magazine with a cartridge in position 0, and
no cartridge is in the drive, the final power-on self-test (POST) status
displays:
Power On indicator on
Eject indicator on
Load/Unload indicator on
Slot Select indicator on
Slot 0 indicator on
2. If a fault occurs, refer to Chapter 9 or the Magazine Tape ISE service
manual.
Proceed to Section 8.3.1 once these steps are accomplished and the magazine
tape ISE has passed POST.
8.3.1 Updating the System Configuration Sheet
Now that the magazine tape ISE has been successfully installed, power has
been applied, and the drives have passed POST, you are ready to update the
system configuration sheet.
Refer to the KFMSA Module Installation and User Manual for complete details
on filling out a system configuration sheet.
Installing the Magazine Tape ISE in a DECarray Cabinet 8–35