Installation guide

Installing the Magazine Tape ISE in a DECarray Cabinet
8.2 Cabling the Magazine Tape ISE
8. If there is no TF8x7 storage enclosure installed in position 2, then at the
rear of the DECarray cabinet, locate the DSSI I/O panel at the bottom. Use
a 3/16-inch flatblade screwdriver to loosen the two captive screws at the
right of the panel.
9. Swing open and remove the panel from the cabinet frame.
CAUTION
Use care not to disturb or damage power cords and DSSI cables that
are already connected to the DSSI I/O panel.
10. Install a 70-inch DSSI cable (PN BC21R–5L) to port 2 on the DECarray I/O
panel by first removing the panel blank.
11. Connect the other end of this 70-inch DSSI cable to the top DSSI connector
on the rear of the magazine tape ISE.
12. Install a 70-inch DSSI cable (PN BC21R–5L) to port 10 on the DECarray
I/O panel by first removing the panel blank.
13. Connect the other end of this 70-inch DSSI cable to the bottom DSSI
connector on the rear of the magazine tape ISE.
8–34 Installing the Magazine Tape ISE in a DECarray Cabinet