Installation guide

Installing the Magazine Tape ISE in a DECarray Cabinet
8.2 Cabling the Magazine Tape ISE
3. Pull the inner assembly out to the head cleaning position (first mechanical
stop).
4. Connect the 70-inch DSSI cable removed from position 1 (Figure 8–10) and
connect it to the top DSSI connector on the rear of the magazine tape ISE.
Route this DSSI cable under the cable retainers on the right side of the
cabinet.
5. Connect a 42-inch DSSI cable (PN BC21Q–3F) to the rightmost DSSI
connector at the rear of the TF8x7 in position 1 and to the bottom DSSI
connector at the rear of the magazine tape ISE in position 5. Route this
DSSI cable under the cable retainers on the right side of the cabinet.
6. Push the inner assembly back into the extrusion tube.
CAUTION
Do not power up the magazine tape ISE or the TF8x7 storage enclosure
at this time.
Installing the Magazine Tape ISE in a DECarray Cabinet 8–23