Installation guide

Installing the Magazine Tape ISE in a DECarray Cabinet
8.1 Installing the TF8x7 Storage Enclosure
d. At the front of the cabinet, lift the extrusion tube up and onto the slide
mount until the chassis retainers touch the weldment brackets.
e. Install and tighten the two outer weldment screws, then install and
tighten the two inner weldment screws (Figure 8–8).
f. Tighten the upper and lower weldment 1/2-inch shoulder screws and
washers.
Figure 8–8 Securing the Tube to the Weldment Brackets
SHR-X0132A-90
LOCK WASHER (2)
90-07651-03
1/2-INCH PHILLIPS
SCREW (2)
CHASSIS RETAINER (2)
74-35858-01
SLIDE MOUNT
HARDWARE
HERE IS
SAME AS
LISTED
ABOVE
1 1/2-INCH PHILLIPS
SCREW (2)
90-06079-03
90-06079-02
Installing the Magazine Tape ISE in a DECarray Cabinet 8–19