Installation guide

Installing the Magazine Tape ISE in a DECarray Cabinet
8.1 Installing the TF8x7 Storage Enclosure
3. Install the magazine tape ISE.
a. Loosen the shipping screw in the rear, upper right corner of the
magazine tape ISE.
b. Remove the magazine tape ISE assembly from the extrusion tube.
Push the inner assembly out to the first mechanical stop. Release the
stop and then push the inner assembly out to the second mechanical
stop. Then remove the inner assembly from the extrusion tube. Place
the inner assembly to one side.
CAUTION
Do NOT open the front of the magazine tape ISE inner assembly while
the inner assembly is out of the extrusion tube.
c. Install both chassis retainers on the front, right side (position 5) or left
side (position 6) of the extrusion tube (top and bottom, Figure 8–7).
Installing the Magazine Tape ISE in a DECarray Cabinet 8–17