Installation guide

Installing the Magazine Tape ISE in a DECarray Cabinet
8.1 Installing the TF8x7 Storage Enclosure
2. Install the slide mount and associated hardware (Figure 8–5).
The slide mount has two parts; the adjustable end and the slotted end. The
adjustable end has four screws that, when loosened, allow the slide mount
to be placed in the cabinet and then extended to make a secure fit.
When installing the slide mount in positions 3, 5, and 7, install the slotted
end in the front left cabinet frame rail. When installing the slide mount in
positions 2, 4, 6, and 8, install the adjustable end in the front right cabinet
frame rail. The position numbers are visible on both the right and left
cabinet frame rails from either the front or the rear.
a. Loosen the four screws in the adjustable end of the slide mount.
b. From the front of the cabinet, place the slide mount in the cabinet so
that the stamped UP and arrow are visible.
c. Align the guide pin with the X stamped in the cabinet frame rail.
d. Install one 7/16-inch shoulder screw and washer (hand-tighten) in the
center threaded hole of the slide mount.
e. Install the opposite end of the slide mount into the rear cabinet side
rail. Again, align the guide pins with the X on the rail.
f. Install one 7/16-inch shoulder screw and washer (hand-tighten) in the
center threaded hole of the slide mount.
g. At the rear of the cabinet, install two 1/2-inch shoulder screws with
washers and the DSSI cable retainer clip. Note that the DSSI cable
retainer clip must always point away from the center of the cabinet and
that it is installed on the lower half of the slide mount.
• At the rear of the cabinet, install two 1/2-inch shoulder screws with
washers and the DSSI cable retainer clip. Note that the DSSI cable
retainer clip must always point away from the center of the cabinet.
• Place a 1/2-inch shoulder screw with a washer through the lower
hole of the DSSI cable retainer clip and install the screw (hand-
tighten) in the bottom threaded hole in the slide mount.
• Place the other 1/2-inch shoulder screw with a washer through the
upper hole of the DSSI cable retainer clip and install the screw
(hand-tighten) in the threaded hole in the slide mount.
h. While facing the rear of the cabinet, install two 7/16-inch shoulder
screws with washers (hand-tighten)—one screw in the bottom threaded
hole and the other in the threaded hole beneath the center rear
shoulder screw (hand-tighten) previously installed.
8–14 Installing the Magazine Tape ISE in a DECarray Cabinet