Installation guide

Installing the Magazine Tape ISE in a DECarray Cabinet
8.1 Installing the TF8x7 Storage Enclosure
8.1.4 Installation Procedure
This section describes the step-by-step procedures for installing a magazine
tape ISE in a DECarray cabinet.
Be sure to:
• Follow each step in order, and do not skip any steps
• Leave sufficient room to perform the installation (approximately 1.5 meters
to 1.8 meters [5 feet to 6 feet] front and rear of the DECarray)
WARNING
Observe all ESD precautions and procedures.
An antistatic wrist strap is inside the front and rear doors.
CAUTION
Do not attempt to pick up or support the product by the rear of the
enclosure. Doing so will injure the person attempting the installation
or damage the power supply.
To maintain stability, extend only one TF8x7 storage enclosure or
magazine tape ISE on the slide mounts at a time.
Installing the Magazine Tape ISE in a DECarray Cabinet 8–9