Installation guide

Field Add-On with Universal Mounting Kit H229-AB/AC

7.2 Mounting the Storage Enclosure

Once the chassis rail is installed in the cabinet, the enclosure can be mounted

on it. Mount the enclosure to the chassis rail as follows:

Note

The lock down brackets are mirror images of each other, and they are

identiﬁed as the -03 and -04 versions. They must be installed with the

orientation shown in the illustration.

1. Install the the two lock down brackets on the side of the enclosure near the

front end, as shown in either 7–5 or 7–6. Figure 7–5 shows the installation

for the right mounting position, and Figure 7–6 shows the installation for

the left mounting position.

WARNING

Use two persons to lift the enclosure. The unit is heavy and awkward

to lift. Failure to use two persons to lift the enclosure may result in

injury or damage to equipment.

2. From the front of the cabinet and using two persons, position the enclosure

such that the machined grooves in the side of the enclosure mate with the

upper and lower edges of the chassis rail.

CAUTION

Use care when sliding the enclosure into the cabinet. Do not allow

the enclosure to pull or pinch cables that may be routed through the

cabinet interior. Failure to use care when mounting the enclosure may

result in equipment damage.

3. Slide the enclosure onto the chassis rail until the lockdown brackets

contact the U-nuts on the front vertical cabinet rail.

4. Fasten the lock down brackets to the front vertical chassis rail with two

hex cap screws, as shown in Figure 7–5 or 7–6.

Field Add-On with Universal Mounting Kit H229-AB/AC 7–11