Installation guide

Installing the SF7x Storage Enclosure in a DECarray Cabinet
6.7 Powering Up the SF7x
6.7.1 Updating the System Configuration Sheet
Once the enclosure has been successfully installed, power has been applied,
and the drives have passed POST, you are ready to update the system
configuration sheet to add the new ISEs.
Refer to the KFMSA Module Installation and User Manual for complete details
on filling out a system configuration sheet.
6.8 Labeling the DSSI Cables and OCP
For a single-system configuration, use the following colored labels on the SF7x
OCP door, magazine tape ISE front panel, and all DSSI cables:
Label Colors Connections
Blue Port 1, positions 5, 1, 3
Red Port 2, positions 6, 2, 3
Yellow Port 3, positions 4, 8
Green Port 4, positions 7, 8
For a DSSI VAXcluster configuration, use the following colored labels on the
SF7x OCP door, magazine tape ISE front panel, and all DSSI cables:
Label Colors Connections
Blue Port 1, positions 5 and 1, port 9
Red Port 2, positions 6 and 2, port 10
Yellow Port 3, position 3, port 11
Green Port 4, position 4, port 12
Blue with white stripe Port 5, position 7, port 13
Red with white stripe Port 6, position 8, port 14
Installing the SF7x Storage Enclosure in a DECarray Cabinet 6–53