Installation guide

Installing the SF7x Storage Enclosure in a DECarray Cabinet
6.6 Cabling the SF7x in a DECarray Cabinet
6. Plug the other end of the 70-inch DSSI cable from the right port into the
rightmost DSSI connector at the rear of the SF7x.
7. Route this DSSI cable under the cable retainers on the right side of the
cabinet.
8. Plug the other end of the 70-inch DSSI cable from the left port into the
leftmost DSSI connector at the rear of the SF7x enclosure.
9. Route the DSSI cable under the cable retainers on the left side of the
cabinet.
10. Plug two 108-inch DSSI cables (PN BC21Q–09) into the right and left ports
and tighten the retainer screws with your fingers.
Note
The following step assumes that no storage enclosures are installed
internally in the system cabinet. If there are storage enclosures
installed in the system cabinet, then one of the KFMSA modules
installed in the system XMI backplane must be connected to those
storage enclosures. Do NOT use this KFMSA module or its DSSI
connections to connect the system to the DECarray.
11. Plug the other end of the 108-inch DSSI cables into the appropriate ports
on the system I/O panel at the rear of the system cabinet.
CAUTION
Do not apply power to the storage enclosure at this time.
Installing the SF7x Storage Enclosure in a DECarray Cabinet 6–49