Installation guide

Installing the SF7x Storage Enclosure in a DECarray Cabinet
6.6 Cabling the SF7x in a DECarray Cabinet
5. Pull the inner assembly of the magazine tape ISE out to the head cleaning
position (first mechanical stop).
6. Route the DSSI cable under the cable retainers on the right side of the
cabinet. Cabling the magazine tape ISE with the inner assembly pulled
out to the head cleaning position ensures that the correct cable slack is
provided when the inner assembly is pushed back into the extrusion tube.
7. Push the inner assembly of the magazine tape ISE back into the extrusion
tube.
8. Connect the 42-inch DSSI cable from the bottom DSSI connector on the
rear of the magazine tape ISE to the rightmost DSSI connector on the rear
of the SF7x storage enclosure.
Note
Perform the next step if this is the only storage enclosure to be
installed on this particular DSSI bus. If not, then proceed to the
cabling instructions for the next storage enclosure that has been
installed.
9. Install a DSSI terminator in the leftmost DSSI connector at the rear of the
SF7x.
CAUTION
Do not apply power to the storage enclosure at this time.
6–36 Installing the SF7x Storage Enclosure in a DECarray Cabinet