Installation guide

Installing the SF7x Storage Enclosure in a DECarray Cabinet
6.5 Installation Procedure
h. While facing the rear of the cabinet, install two 7/16-inch shoulder
screws with washers (hand-tighten)—one screw in the bottom threaded
hole and the other in the threaded hole beneath the center rear
shoulder screw (hand-tighten) previously installed.
i. While facing the front of the cabinet, install two 7/16-inch shoulder
screws with washers (hand-tighten)—one screw in the bottom threaded
hole and the other in the threaded hole beneath the center rear
shoulder screw (hand-tighten) previously installed.
j. Tighten all shoulder screws.
k. Tighten the four slide mount screws.
Figure 6–5 Installing the Slide Mount
LOCKWASHER (5)
90-06637-00
7/16-INCH SHOULDER SCREW (3)
12-24007-02
DSSI CABLE RETAINER
74-41302-01
LOCKWASHER (3)
90-06637-00
SLIDE MOUNT
NOTE TO ILLUSTRATOR:
This is reduced at 18%
of original
7/16-INCH
SHOULDER
SCREW (3)
12-24007-02
1/2-INCH
SHOULDER
SCREW (2)
12-24007-01
SHR-X0130A-90
Installing the SF7x Storage Enclosure in a DECarray Cabinet 6–15