Installation guide

Installing the SF3x Storage Enclosure in a DECarray Cabinet

5.9 Installing a SF36-xx Storage Enclosure in a SF2xx Cabinet

Table 5–5 SF3x Factory-Set DSSI Node IDs

Upper Lockdown

Bracket

Part No.

Lower Lockdown Bracket

Part No.

Odd No. Position Side 74–44472–04 74–44472–03

Even No. Position Side 74–44472–03 74–44472–04

WARNING

A lifting device or three people are required to lift and position the

storage enclosure in the cabinet. Failure to use a lifting device or

sufﬁcient personnel may result in injury and equipment damage.

3. With the lockdown bracket end facing away from the cabinet, lift the

SF36-xx storage enclosure assembly up and into the universal slide mount.

The upper and lower edges of the slide mount should mate with the grooves

in the sides of the enclosure extrusion.

4. Push the storage enclosure all the way into the cabinet along the slide

mount until the lockdown brackets contact the U-nuts preinstalled on the

front cabinet rails.

5. Fasten the lockdown brackets to the cabinet rails by installing cap screws

through the brackets and into the U-nuts, as shown in Figure 5–22.

6. Resume hardware installation with Section 5.4.2, step 4.

Installing the SF3x Storage Enclosure in a DECarray Cabinet 5–43