Installation guide

Installing the SF3x Storage Enclosure in a DECarray Cabinet
5.6 Powering Up the SF3x Enclosure
5.6.1 Updating the System Configuration Sheet
Once the enclosure has been successfully installed, power has been applied,
and the drives have passed POST, you are ready to update the system
configuration sheet to add the new ISEs.
Refer to the KFMSA Module Installation and User Manual for complete details
on filling out a system configuration sheet.
5.7 Labeling the DSSI Cables
Use the following colored labels on the magazine tape ISE front panel and all
DSSI cables:
Label Color I/O Port SF3x Position
Blue 1 1 Rear
Red 2 1 Front
Yellow 3 2 Rear
Green 4 2 Front
Blue & white 5 3 Rear
Red & white 6 3 Front
Yellow & white 7 4 Rear
Green & white 8 4 Front
Blue, red 9 7 Rear
Yellow, green 10 7 Front
Blue, red & white 11 8 Rear
Yellow, green & white 12 8 Front
5–40 Installing the SF3x Storage Enclosure in a DECarray Cabinet