Installation guide

Installing the SF3x Storage Enclosure in a DECarray Cabinet

5.5 Cabling the SF3x in the DECarray Cabinet

Figure 5–18 Cabling an SF3x in Through-Bus Mode

MA-0437-92.DG

Terminator

5.5.1.3 Cabling Positions 2, 3, 4, 7, and 8

CAUTION

Before performing the following steps, refer to the system documenta-

tion for the correct procedure to perform an orderly shutdown of the

system that the DECarray is connected to.

1. At the rear of the DECarray, locate the DSSI I/O panel at the bottom. Use

a 3/16-inch ﬂatblade screwdriver to loosen the two captive screws at the

right of the panel.

2. Swing open and remove the panel from the cabinet frame.

CAUTION

Use care not to disturb or damage power cords and DSSI cables that

are already connected to the DSSI I/O panel.

3. Remove the two Phillips screws that hold the panel blank in the

appropriate ports of the I/O panel. Refer to Section A.4 to identify the

appropriate I/O ports for your installation.

5–34 Installing the SF3x Storage Enclosure in a DECarray Cabinet