Installation guide

Installing the SF3x Storage Enclosure in a DECarray Cabinet
5.4 Installation Procedure
CAUTION
Observe all ESD precautions and procedures. An antistatic wrist strap
is provided inside the DECarray front and rear doors.
6. Install the OCP (Figure 5–13).
Note
Make sure that the power is off to the enclosure.
Make sure that ALL the buttons are in the out position.
7. Make sure that all drive dc power switches are out (Figure 5–13).
8. At the rear of the SF3x enclosure, make sure that the ac power switch is in
off or in the 0 position (Figure 5–14).
9. Also check the select line voltage. Set it to the correct setting for your
application.
10. At this time, connect the ac power cord to the SF3x enclosure.
5–26 Installing the SF3x Storage Enclosure in a DECarray Cabinet