Installation guide

Installing the SF3x Storage Enclosure in a DECarray Cabinet

5.4 Installation Procedure

5. Make sure the DSSI node ID assignments are correct. The DSSI node

ID for each slot in the SF3x backplane comes factory set, as shown in

Table 5–3. However, some conﬁgurations may require you to change the

DSSI node ID to something other than the factory setting.

Table 5–3 SF3x Factory-Set DSSI Node IDs

Position Backplane Location DSSI Node ID

A upper left slot 0

B upper right slot 1

C middle left slot 2

D middle right slot 3

E lower left slot 4

F lower right slot 5

You can change the DSSI node ID for an ISE in any given slot position by

using DIP switches provided on the SF3x enclosure’s transition module.

Figure 5–12 shows the location of the switches for each slot position.

Table 5–4 shows what the switches must be set to for each slot position.

5–22 Installing the SF3x Storage Enclosure in a DECarray Cabinet