Installation guide

Installing the SF3x Storage Enclosure in a DECarray Cabinet
5.4 Installation Procedure
2. Install the slide mount and associated hardware (Figure 5–7).
The slide mount has two parts, the adjustable end and the slotted end. The
adjustable end has four screws that, when loosened, allow the slide mount
to be placed in the cabinet and then extended to make a secure fit.
When installing the slide mount in positions 1, 3, 5, and 7, install the
slotted end in the front left cabinet frame rail. When installing the slide
mount in positions 2, 4, 6, and 8, install the adjustable end in the front
right cabinet frame rail. The number for each position is labeled on the
right and left cabinet frame rail on the front and the rear of the cabinet.
a. Loosen the four screws in the adjustable end of the slide mount.
b. From the front of the cabinet, place the slide mount in the cabinet so
that the stamped UP and arrow are visible.
c. Align the guide pin with the X stamped in the cabinet frame rail.
d. Install one 7/16-inch shoulder screw and washer (hand-tighten) in the
center threaded hole of the slide mount.
e. Install the opposite end of the slide mount into the rear cabinet side
rail. Again, align the guide pins with the X on the rail.
f. Install one 7/16-inch shoulder screw and washer (hand-tighten) in the
center threaded hole of the slide mount.
g. At the rear of the cabinet, install two 1/2-inch shoulder screws with
washers and the DSSI cable retainer clip. Note that the DSSI cable
retainer clip must always point away from the center of the cabinet.
• Place a 1/2-inch shoulder screw with a washer through the upper
hole of the DSSI cable retainer clip and install the screw (hand-
tighten) in the top threaded hole in the slide mount.
• Place the other 1/2-inch shoulder screw with a washer through the
lower hole of the DSSI cable retainer clip and install the screw
(hand-tighten) in the threaded hole in the slide mount.
5–14 Installing the SF3x Storage Enclosure in a DECarray Cabinet