Installation guide

Installing the SF3x Storage Enclosure in a DECarray Cabinet
5.4 Installation Procedure
5.4.2 Hardware Installation Procedures
Perform the following steps completely and in the order presented.
CAUTION
Before performing the following steps, refer to the system
documentation for the correct procedure to perform an orderly
shutdown of the system that the DECarray is connected to.
1. Install the ac power cord (Figure 5–6).
a. Go to rear of cabinet. Open the DSSI I/O panel by loosening the two
captive screws on the right.
CAUTION
Use care not to disturb or damage power cords and DSSI cables that
are already connected to the DSSI I/O panel.
b. Locate the ac power cord retainer bracket at the level that you are
installing the SF3x storage enclosure.
c. Loosen the lower screw of the ac retainer bracket. Remove the upper
ac power cord retainer bracket screw and tilt the retainer 45 degrees.
Then retighten the lower screw.
d. Place the ac power cord in the retainer space with the shrouded male
plug end inside the cabinet side rail.
e. Leave approximately 0.6 meters (2 feet) of slack at the position location.
f. Loosen the lower screw and put the retainer bracket back to its original
position. Then reinsert the upper screw and tighten both the top and
bottom screws.
g. Connect the male end of the ac power cord to an outlet on the power
controller, making sure to maintain a proper balance on the phase
loading.
5–12 Installing the SF3x Storage Enclosure in a DECarray Cabinet