Installation guide

5
Installing the SF72 Storage Enclosure in
an SF200 Storage Array
This chapter describes the steps to install the SF72 storage enclosure in
an existing SF200 storage array:
• Steps to install (Section 5.1)
• Cabling the SF72 (Section 5.2)
Single-host configuration (Section 5.2.1)
Dual-host configuration (Section 5.2.2)
• Powering up the SF72 (Section 5.3)
• Labeling the DSSI cables and OCP (Section 5.4)
• Final verification (Section 5.5)
If you are attempting to install an SF72 in a cabinet other than an SF200
storage array cabinet, refer to the host system documentation.
Only Digital Customer Services and other installing personnel that have
been trained in ESD procedures can use the procedures in this chapter.
Follow all the steps in this chapter to install an SF72 storage enclosure in
an SF200 storage array. The steps apply for any position (1, 2, 3, 4, 7, or
8) in the storage array.
Table 5–1 lists the tools required to install the SF72 enclosure into the
storage array.
5–1