Installation guide

4–42 Installing an SF200 Storage Array with a VAX 6000 Series System
4.4.3 Labeling the Cables (Dual-Host)
This section describes the steps to label correctly the cables for the
VAX 6000 series system, the SF200 storage array, and its SF72 storage
enclosures and magazine tape subsystems.
At this point, all steps in the previous sections must be complete.
Digital Customer Services or trained installing personnel must perform
the steps that follow.
4.4.3.1 Completing the System Configuration Sheet (Dual-Host)
At this time, you should be ready to fill out the system configuration
sheet. Examples of these sheets are in Chapter 2 and in the KFMSA
Module Installation and User Manual (EK–KFMSA–IM). Refer to these
examples when filling out the system’s configuration sheet.
NOTE
Do not attempt to fill out and place the labels until you have
completed the system configuration sheet.
The information from the system configuration sheet is used to fill out the
labels correctly for all DSSI cables, enclosure OCPs, and subsystems.
You can also refer to the inside cover of the SF Family Label Booklet (part
number 36–32882–01) for instructions on how to fill out these labels.