Installation guide

4–40 Installing an SF200 Storage Array with a VAX 6000 Series System
c. Install one end of the 108-inch DSSI cable (part number BC21Q–
09) to the I/O panel on the system cabinet (Figure 4–20).
• Connect the DSSI cable from the DSSI port 1 (of the I/O panel)
to the first DSSI connector of the first KFMSA bulkhead
connector on the system I/O panel.
• Connect the DSSI cable from the DSSI port 2 (of the I/O
panel) to the second DSSI connector of the first KFMSA
bulkhead connector on the system I/O panel.
• Connect the DSSI cable from the DSSI port 3 (of the I/O
panel) to the first DSSI connector of the second KFMSA
bulkhead connector on the system I/O panel.
• Connect the DSSI cable from the DSSI port 4 (of the I/O panel)
to the second DSSI connector of the second KFMSA bulkhead
connector on the system I/O panel.
• Connect the DSSI cable from the DSSI port 5 (of the I/O panel)
to the first DSSI connector of the third KFMSA bulkhead
connector on the system I/O panel.
• Connect the DSSI cable from the DSSI port 6 (of the I/O panel)
to the second DSSI connector of the third KFMSA bulkhead
connector on the system I/O panel.
Note that SF200 I/O panel DSSI ports 7, 8, 15, and 16 are not used.