Installation guide

4–20 Installing an SF200 Storage Array with a VAX 6000 Series System

4.3.3.2 Filling Out the Labels (Single-Host)

There are two sizes of labels: the larger one for the DSSI cables, and the

smaller one for the inside of the SF72 OCP door and the system I/O panel.

Refer to the inside cover of the SF Family Label Booklet (part number

36–32882–01) for instructions on what information to put on each of the

two types of labels.

For the single-host conﬁguration, use the following colored labels on the

SF72 OCP door, the front panel of the magazine tape subsystem, and all

DSSI cables.

Label Color Port Position

Blue 1 5, 1, 3

Red 2 6, 2, 3

Yellow 3 4, 8

Green 4 7, 8

Proceed once you have ﬁlled the cable and OCP labels according to the

instructions on the inside cover of the SF Family Label Booklet (part

number 36–32882–01).

4.3.3.3 Placing the Labels (Single-Host)

Now that the labels have all been ﬁlled out, place them on the DSSI

cables and the SF72 OCP doors. Also place a label on the front of the

magazine tape subsystem.

On the DSSI cable, place the label 2 inches behind the DSSI connector

(Figure 4–7).