Installation guide

4–16 Installing an SF200 Storage Array with a VAX 6000 Series System
c. Install one end of the 108-inch DSSI cable (part number BC21Q–
09) to one of the ports on I/O panel at the bottom rear of the
system cabinet (Figure 4–6).
1. Connect the DSSI cable from the DSSI port 1 (of the I/O panel)
to the first DSSI connector of the first KFMSA bulkhead
connector on the system I/O panel.
2. Connect the DSSI cable from the DSSI port 2 (of the I/O
panel) to the second DSSI connector of the first KFMSA
bulkhead connector on the system I/O panel.
3. Connect the DSSI cable from the DSSI port 3 (of the I/O
panel) to the first DSSI connector of the second KFMSA
bulkhead connector on the system I/O panel.
4. Connect the DSSI cable from the DSSI port 4 (of the I/O panel)
to the second DSSI connector of the second KFMSA bulkhead
connector on the system I/O panel.