Installation guide

Installing an SF200 Storage Array with a VAX 6000 Series System 4–9
c. Ensure that all OCP buttons are in the out position.
d. Ensure that the OCP itself is correctly seated in the SF72
enclosure. To do so, place a thumb on either side of the OCP
and press in (Figure 4–2).
e. Ensure that all drive dc power switches (lower half of the
enclosure) are in the out position.
Write
Protect
Ready Fault
DSSI
ID
Write
Protect
Ready Fault
DSSI
ID
d
i g i
t
a l
SHR_X1127A_89
PUSH
PUSH
Figure 4–2 Seating the SF72 OCP
WARNING
Adhere to electrostatic discharge (ESD) procedures at all
times. Use the ESD straps available with every storage array.
The straps are inside the front and rear doors.