Installation guide

4–2 Installing an SF200 Storage Array with a VAX 6000 Series System
4.1 Single-Host Overview
As many as two SF200 storage arrays can be used with a VAX 6000 series
system in a single-host configuration.
A single SF200 storage array requires one or two KFMSA modules
(installed in the system’s XMI backplane) to support the DSSI ISEs
resident in the SF200 storage array.
A second storage array requires one or two additional KFMSA modules.
In a single-host configuration, one tape ISE and, or up to, six disk ISEs
can be connected to one DSSI bus. For further information on single-host
configurations, refer to the KFMSA Module Installation and User Manual
(EK–KFMSA–IM).
Refer to Table 4–1 to confirm that the correct system configuration exists
to support the installation of the array or arrays.