Installation guide

4
Installing an SF200 Storage Array with a
VAX 6000 Series System
This chapter describes the steps to install the SF200 storage array
correctly and safely with an existing VAX 6000 series system in two
configurations:
• Single-host installation (Section 4.3)
• Dual-host installation (Section 4.4)
Perform the steps in the appropriate section only after you have completed
all the steps in Chapter 3.
Ensure that all precautions for site preparation have been completed.
Refer to Chapter 2.
Digital Customer Services or trained installing personnel must perform
the step in the following WARNING:
WARNING
Hazardous voltages are in the storage array and in the
components of the storage array.
When performing any operation involving the power source, turn
off the power controls of all components and on the 881 power
controller. Disconnect the power cable from the source outlet.
Perform the operation, then reconnect the power cable to the
source.
4–1