Installation guide

Unpacking and Placing an SF200 Storage Array with a VAX 6000 Series System 3–11
3.5 Inspecting the Storage Array
Inspect the storage array first from the front, then from the rear.
1. Open the front and rear cabinet doors.
a. Turn the two hex-Allen fasteners at the right edge of each door
counterclockwise to unlock.
b. For each door, grasp the door by its edge, and pull toward you.
2. At the front of the SF200 storage array, verify that all operator control
panels are correctly seated on each SF72 storage enclosure installed
in the cabinet (Figure 3–6).
WARNING
Adhere to electrostatic discharge (ESD) procedures at all
times. Use the ESD straps available with every storage array.
The straps are inside the front and rear doors.
Write
Protect
Ready Fault
DSSI
ID
Write
Protect
Ready Fault
DSSI
ID
d
i g i
t
a l
SHR_X1127A_89
PUSH
PUSH
Figure 3–6 Verifying the SF72 OCP Seating