Installation guide

3–10 Unpacking and Placing an SF200 Storage Array with a VAX 6000 Series System
3.4 Leveling the Array
Once the array is in its final position:
1. Loosen the locknuts on all four leveler feet (Figure 3–5).
2. Turn each leveler hex nut clockwise until the leveler foot contacts the
floor.
3. Adjust all four feet until the cabinet is level and the load is removed
from all casters. Verify that the casters spin freely.
4. Tighten the locknuts on all four leveler feet (Figure 3–5).
LOCKNUT
LEVELER
HEX NUT
LEVELER
FOOT
CXO-395C_S
SHR_X1105_89_SCN
Figure 3–5 Adjusting Leveler Feet