Installation guide

Index 3
SF200 storage array
labeling (Cont.)
single-host configuration,
4–19
labeling, dual-host, C–14
leveling, 3–6
overview, 1–1 to 1–4
powering up
dual-host configuration, 4–47
single-host configuration,
4–24
recommended environmental
limits, 1–3
unpacking, 3–2
SF200 storage array cabling
diagrams, A–1
SF72 enclosure, unpacking, 5–4
SF72 enclosure, where to install,
5–6
SF72 storage enclosure
overview, 1–4 to 1–8
positions, 1–1
recommended environmental
limits, 1–7
SF72 storage enclosure, in an SF200
storage array, 5–11
Single-host configuration, 4–2, 6–26
cabling an SF72 for, 5–35
Site preparation, SF200, 2–1
Slide mount, 5–15, 6–16
Split- and through-bus modes, 4–28,
4–51, 5–4, C–19
Split-bus mode, 1–6, 5–6
converting to,, 5–22
System configuration sheet, 5–8
dual-host, C–14
dual-host configuration, 4–42
magazine tape subsystems, 6–8
single-host configuration, 4–19
updating, 5–74
T
Thermal stabilization, 3–2
Through- and split-bus modes, 4–28,
4–51, 5–4
Through-bus mode, 1–6, C–19
Through-us mode
converting to,, C–6
Tools, SF200 storage array, 5–1, 6–1
Troubleshooting
basic steps, 7–2
installation, 7–1
magazine tape subsystem, 7–15
SF72 storage enclosure, 7–2
Troubleshooting chart, 7–3
U
Unloading procedures, storage array,
3–3
Unpacking, magazine tape
subsystem, 6–3
Unpacking, SF72 enclosure, 5–4
Update the system configuration
sheet, 6–41
V
Verification, final
dual-host configuration, 4–52
single-host configuration, 4–29
W
Weldment bracket, 5–17, 6–19
Where to install, magazine tape
subsystems, 6–6
Where to install, SF72 storage
enclosure, 5–6