Installation guide

2 Index
Installing an SF72 enclosure in an
SF200 Storage Array, 5–1
Installing an SF72 Storage enclosure
SF200 storage array, 5–3
Installing RF72 disk ISE into an
SF72-HK storage enclosure,
B–4
K
KFMSA bulkhead connector, 4–16,
4–40
L
Labeling the cables, 5–75, 6–42
Labeling the DSSI cables, 5–74
magazine tape subsystem, 6–42
Labeling the magazine tape
subsystem, 6–42, 6–44
Labeling the operator control panel,
5–74, 5–76
M
Magazine tape subsystem
in an SF200 storage array, 6–11
shipping screw, 4–12
Magazine tape subsystem,
unpacking, 6–3
Magazine tape subsystem, where to
install, 6–6
P
Placing DSSI terminators, 4–18
Placing the labels
Dual-host, C–16
dual-host configuration, 4–44
single-host configuration, 4–20
Powering up, SF200 storage array
dual-host configuration, 4–47
single-host configuration, 4–24
Powering up the magazine tape
subsystem, 6–41
Powering up the SF72 storage
enclosure, 5–73
Power up the SF200 storage array
Dual-host, C–19
Preparing, the SF200 storage array,
5–12
Preparing, the SF200 Storage Array,
6–12
Procedures, safety, 3–3
Procedures, storage array unloading,
3–3
R
Ramp inspection, 3–3
Rear door removal, 3–11, 4–7, 4–31
Removing the RF72 disk ISE
SF72 storage enclosure, 7–6
S
Safety procedures, storage array
unloading, 3–3
SF200 shipping container contents,
3–2
SF200 storage array
cabling
dual-host configuration, 4–39
single-host configuration,
4–15
inspection, 3–11
dual-host configuration, 4–31
single-host configuration, 4–7
installation
dual-host configuration, 4–30
single-host configuration, 4–6
installation of, 4–1
installing a magazine tape
subsystem, 6–1
installing an SF72 enclosure, 5–1
labeling
dual-host configuration, 4–42