Installation guide

C–22 Converting a Single-Host Conﬁguration to a Dual-Host Conﬁguration

C.2.6 Final Veriﬁcation

Now that the SF200 storage array has been converted, cabling and

labeling, and the powered up, you are ready to conﬁgure the DSSI

subsystem and verify the correct operation of each ISE in the array

with the host system.

Refer to the KFMSA Module Installation and User Guide, EK–KFMSA–

IM, TF837 Magazine Tape Subsystem Service and Installation Manual,

EK–TF837–IM, and the RF31/RF72 Intregrated Storage Element User

Guide, EK–RF72D–UG) for the detailed information and how to proceed

with verifying the correct operation of each ISE that has been installed.

In these manuals you will ﬁnd the procedure for establishing the

communications between the ISEs, the adapter module, and the system.

You will also ﬁnd the step by step procedures for reconﬁguring the system

with its newly installed DSSI devices.

Refer to the manuals for the disk ISE and tape ISE for detailed

information of the local programs contained within the ISEs.

REMEMBER, each SF72 enclosure can contain 2 or 4 disk ISEs. Each

magazine tape subsystem contains one tape ISE. A fully conﬁgured

storage array contains 24 disk ISEs and 2 tape ISEs.