Installation guide

C–16 Converting a Single-Host Conﬁguration to a Dual-Host Conﬁguration

C.2.3.2 Filling Out the Labels

There are sizes of colored labels. The larger label is for the DSSI cables.

The smaller label is for the inside of the SF72 stroage enclosure OCP

door, the front panels of a magazine tape subsystem and the host system

I/O panel.

Refer to the inside cover of the SF Family Label Booklet, part number

36–32882–01, for the instructions on what information to put on each of

the two types of labels.

For dual-host, the following colored labels are to be used on the SF72

storage enclosure OCP doors, magazine tape subsystem front panels, and

all DSSI cables.

COLOR SF200 Port/SF200 Position

Blue labels port 1, positions 5 and/or 1, port 9

Red labels port 2, positions 6 and/or 2, port 10

Yellow labels port 3, position 3, port 11

Green labels port 4, position 4, port 12

Blue with white strip labels port 5, position 7, port 13

Red with white strip labels port 6, position 8, port 14

Once you have ﬁlled the cable and OCP labels according to the instruction

on the inside cover of the SF Family Label Booklet, part number 36–

32882–01, then proceed.

C.2.3.3 Placing the Labels

Now that the labels have all been ﬁlled out, place the labels on the DSSI

cables and the SF72 OCP doors. Also place a label on the front of the

magazine tape subsystem.

Cable labels are placed two inches behind the DSSI connector on both

ends of the DSSI cable. Refer to Figure C–7.