Installation guide

C–14 Converting a Single-Host Conﬁguration to a Dual-Host Conﬁguration

C.2.3 Labeling the Cables

This section details the steps required to correctly label all the cables

for the VAX6000 series system’s, the SF200 storage array and its SF72

storage enclosures and tape magazine subsystems.

At this point, all steps in the previous sections must be completed.

C.2.3.1 System Conﬁguration Sheet

At this time you should be ready to ﬁll out the system conﬁguration

sheets. Examples of this sheets can be found in Figure C–6 and in the

KFMSA Module Installation and User Guide, EK–KFMSA–IM. Refer to

these example when ﬁlling out the system’s conﬁguration sheets.

NOTE

Do not attempt to ﬁll out and place the labels until you have all

the information.

The information from the system conﬁguration sheet is used to correctly

ﬁll out the labels for; all DSSI cables, Sf72 storage enclosure OCPs, and

magazine tape subsystem front panels.

You can also refer to the inside cover of the SF Family Label Booklet, part

number 36–32882–01, for instructions on how to ﬁll out these labels.